NTS-QM311 Quick jaw change base jaws Kitagawa
kitagawa
Kitagawa

NTS-QM311 Quick jaw change base jaws

Termékkód: NTS-QM311

Easy jaw exchange
Modification from an existing NTS gripper is possible.
Just by replacing the standard master jaws of your NTS gripper with the quick master jaws, your NTS gripper will become a quick jaw change gripper
One set of hard jaws supports workpieces from φ20 to φ60 on NTS309.
Proximity switches can not be used for the quick jaw change grippers.

Close Force(N): 1810
Open Force(N): 1930
* Air pressure set at 0.6 MPa.
Measurement Distance L(mm): 20
Jaw Stroke: 20mm(dia.), 10mm(per finger)

Küldjön e-mailt a helyi képviseletnek

Close Force(N): 1810
Open Force(N): 1930
* Air pressure set at 0.6 MPa.
Measurement Distance L(mm): 20
Jaw Stroke: 20mm(dia.), 10mm(per finger)
Repeatability(mm): ±0.01
Mass (kg): 1.29
Air Consumption per reciprocating (cm3): 112
Air pressure (MPa): 0.2 ~ 0.8
Operating Temperature (

Note 1. Please install a check valve in the air-pressure circuit so that the gripper will not release a workpiece even if the air pressure drops down.
Note 2. A reed switch bracket is attached.
Note 3: Proximity switches can not be used for the quick jaw change grippers.
Note 4. The material of internal seals of grippers is nitrile rubber. If the fluororubber seals are needed, please consult Kitagawa distributor.

Mutass többet: Grippers | Accessories | Quick jaw change base jaws