NPGT10 Two Jaw Pneumatic Parallel gripper Kitagawa
kitagawa
Kitagawa

NPGT10 Two Jaw Pneumatic Parallel gripper

Code du produit: NPGT10

Thin 2-jaw parallel gripper

The thin body enables flexible system design
The high restoration accuracy by utilizing workholding technology of lathe chucks
NPGT achieves higher gripping force than the similar stroke model
Variety of options including several detection methods and the model with a through hole

Close Force(N): 1000
Open Force(N): 860
* Air pressure set at 0.6 MPa.
Measurement Distance L(mm): 10
Jaw Stroke: 20.8mm(dia.), 10.4mm(per finger)
Through Hole (mm): 7.8

Envoyer un email à un distributeur local

Close Force(N): 1000
Open Force(N): 860
* Air pressure set at 0.6 MPa.
Measurement Distance L(mm): 10
Jaw Stroke: 20.8mm(dia.), 10.4mm(per finger)
Through Hole (mm): 7.8
Repeatability(mm): ±0.008
Mass (kg): 1.25
Air Consumption per reciprocating (cm3): 63
Air pressure (MPa): 0.2 ~ 0.8
Operating Temperature (? ): 5 ~ 60

Note 1: Please install a check valve in the air-pressure circuit so that the gripper will not release a workpiece even if the air pressure drops down.
Note 2: When the jaw stroke is detected by the reed switches, mount reed switched on the grooves on the outer periphery of the product.
Note 3: In case proximity switches are used for direct detection of jaw stroke, please purchase proximity switch brackets additionally.
Note 4: The material of internal seals of grippers is nitrile rubber. If the fluororubber seals are needed, please consult Kitagawa distributor.

Voir plus: Grippers | 2 & 3 jaw grippers for robot arms