ROTARY TABLE WITH MEGA THROUGH HOLE
A servo motor-driven NC rotary table with a very large through-hole has been introduced by Kitagawa to facilitate accurate milling and drilling of tube- and shaft-type components on machining centres.
The 346 mm diameter hole through the centre has been sized to accept pipe up to 13 inches (340 mm), which is a standard used in the oil and gas industry for such applications as borehole casing.??
The Mechanical Structure of the TP530 is designed to withstand the heavy cutting torques (up to 2,600 Nm) required to machine the tough materials used in Aerospace components. ?Hydraulic clamping torque is exceptionally high at 6,100 Nm to allow heavy static machining.??
The TP530 is of rigid build for top machining accuracy, the unit weighs 350 kg, one third less than the equivalent model in Kitagawa TR table series, which has a through-hole only half as large.
Lower rotary table weight means that heavier components can be machined without exceeding the maximum table load of the machine tool.??
Centre height is 310 mm, maximum rotational speed is 11.1 rev/min using a gear reduction ratio of 1/180, and indexing accuracy and repeatability are 20 and 4 seconds of arc respectively.
For further information on the TP530 rotary table please click here or information on any of our products call Kitagawa Europe today on +44 (0)1725 514 010. Alternatively UK based queries can be sent via email to [email protected]. Correspondence sent from outside the UK should be sent to [email protected].
{{previous_news_article}} {{next_news_article}}