NPGT10S Two jaw pneumatic parallel gripper with measuring function | Kitagawa
kitagawa
Kitagawa Middle East

NPGT10S Two jaw pneumatic parallel gripper with measuring function

Product Code: NPGT10S

Thin 2-jaw parallel gripper with measuring capability

Possible to measure gripping length
The thin body enables flexible system design
The high restoration accuracy by utilizing workholding technology of lathe chucks
NPGT achieves higher gripping force than the similar stroke model.

Close Force(N): 1000
Open Force(N): 860
* Air pressure set at 0.6 MPa.
Measurement Distance L(mm): 10
Jaw Stroke: 20.8mm(dia.), 10.4mm(per finger)
Through Hole (mm): 7.8

Email a local distributor

Close Force(N): 1000
Open Force(N): 860
* Air pressure set at 0.6 MPa.
Measurement Distance L(mm): 10
Jaw Stroke: 20.8mm(dia.), 10.4mm(per finger)
Through Hole (mm): 7.8
Repeatability(mm): ±0.008
Mass (kg): 1.25
Air Consumption per reciprocating (cm3): 63
Air pressure (MPa): 0.2 ~ 0.8
Operating Temperature (

Note 1: Please install a check valve in the air-pressure circuit so that the gripper will not release a workpiece even if the air pressure drops down.
Note 2: The length measuring sensor is a factory-installed option. Since optional parts such as cables vary depending on the signal output format, please contact the Kitagawa distributor when ordering the gripper with length measuring sensors.
Note 3: When the jaw stroke is detected by the reed switches, mount reed switched on the grooves on the outer periphery of the product.
Note 4: In case proximity switches are used for direct detection of jaw stroke, please purchase proximity switch brackets additionally.
Note 5: The material of internal seals of grippers is nitrile rubber. If the fluororubber seals are needed, please consult Kitagawa distributor.

View more: Robot Grippers | Grippers with measuring function